This is a special case, tangent space normal maps should be cleared to
0.5, 0.5, 1.0. This is good practice but there's no reason why not to
automate this (for artists whose bump map fu may be a bit shallow).
Thanks to Morten Mikkelsen for reporting.
find ldl symbols because order of libraries seems to be critical
for gcc linker.
A bit stupid, but that's how linker works..
Both CMake and SCons shall work fine on linux now.
Root of the issue goes to SSBA library which didn't work
properly when using optimization in MSVC. It was worked
around by disabling optimization for libmv, which is in
fact shame and shouldn't have been done.
It seems after some changes optimization does not affect
on SSBA code, but enabling optimization could be risky so
close to release.
For now solved by splitting SSBA to separate CMake/SCons
library, disabling optimization only for this particular
library and enabling optimization for rest of libmv.
Tested on all files which used to fail with optimization
enabled in SSBA and all of them works the same as before.
Tracking speed is significantly higher now.
After release we'll enable optimization for SSBA as well,
so there'll be no crappy build setup. Later we'll replace
old SSBA library with new BA code based on Ceres.
Bundle script would be broken for until then, so better
not to use it.
This is a pretty rare case that can be triggered by switching rigid body
and constraint groups before simulation was validated.
Code checked for existing physics objects but was missing else block.
In rare cases this would allow the simulation to run before being
initialized (if cache is baked and reading cache fails after undo or
loading a file).
Before this change only old flag "Premultiply" was used to
detect alpha mode, which is not enough actually.
Now the logic here is:
- If "Premultiply" was enabled it is likely float image with
straight alpha, which shall be premultiplied before usage.
In this case image/sequence Alpha Mode is set to Straight.
- Otherwise use default alpha mode for image format based on
an extension. This could fail in some cases like TIFF, but
this wasn't handled fully correct in older blender anyway.
Initial discovered issue was that EXR images saved in older
Blender versions were set to Straight alpha mode, which is
obviously a straight way to lots of headache.
edit mode
My earlier fix for [#33974] (in r.54061) was causing some problems where
manually specified roll values on horizontal or angled bones were getting reset.
This could be nasty as you might not notice the changes for a while (especially
when using stick bones without axes displayed).
I've now put in place a hacky compromise solution which should catch both of
these situations nicely. For z-axis (i.e. vertical) movements, the r.54061 fix
is used, while for everything else (moving or just touch-n-go), the old setting
is used.
This was caused by a floating point precision error. During collision detection, Newton-Raphson iteration is used to find the exact time of the collision. But when using subframes, the initial Newton step was too small. Now the initial step is given in absolute units. When subframes = 0, this should behave almost the same as before.
Thanks to Janne Karhu, Lukas Toenne and Ton Roosendaal for their help with this patch, and to AutoCRC for funding.
